1 Hp TENV Motor Kit

This Kit Includes:

     1HP Motor

     16-25ft Wire

     Fly Wheel

     Manual Hold Toggle Switch

     Mounting Hardware

These Motors are great for Ahoy Boat Lifts and similar products including Cargo Lifts. The Hardware Included is for mounting on our gear plates only.

Voltage: 110v-220v

Amps: 12.6

R.P.M: 1728

The Elite 1 HP Painted Wired Boat Lift Motor is a single phase, dual-voltage motors. It comes from the factory wired at 110v, but a licensed electrician can convert the wiring to make it a 220v electric motor. The motor is built from rolled steel. The NEMA 56 shaft is 0.625 inch thick and 1.88 inch extruding from the motor housing. UL Recognized (C-UL-US). It uses a capacitor to start.

TENV (totally enclosed, non-ventilated) housing. TENV housing prevents dirt, insects, and water from entering the motor. 15 minutes maximum runtime. Includes 1 inch long x 1/4 inch wide keystock, colored T-wires, easy-to-follow wiring instructions, BH-USA equipment guide, and wiring instructions. Depending on your preference, you can select a maintained (lock-on) or momentary (spring-loaded) drum switch type. The in-line GFCI has a built-in test and reset button.